The supplies you will need are as follows:
- an old book that you can take pages out of (I like it when the pages are kind of yellowed)
- glue dots
- stapler
- (not shown) Xacto knife makes it easier to get the pages out of the book
Step One:
![]() | |||
- Cut the paper into strips that are 9.5 inches long and 1/2 inches wide.
- Cut 3/4 inch off three of the strips and cut 1.5 inches off two of the strips. Final strip is 3 inches long.
- (NOTE: This book has pages that are 9.5" x 7". If you were using a magazine page that was 11" x 8.5", then I would cut them 3/4" wide, cut 1" off three of the strips, and cut 2" off two of the strips. Final strip would be 3.5" long.)
Step Two:
- Twist each strip as shown and staple in the middle.
- Use a glue dot to make the small strip into a circle.
Step Three:
- Use a glue dot for each twist and attach to the twisted strips that are the same size as show above.
Step Four:
- Attach sections with glue dots to get completed bow as shown above.
Finished Bow -
![]() |
| You can add extra strips as shown to make the ribbon streamers, if desired. |











